WATCH THE VIDEO:  https://youtube.com/shorts/n2xaNUJv5vs

(Cleaning the Glass Top)
To clean your CARTA Sport, make sure your device is turned off. Once it's off, carefully remove the glass top, the atomizer, any silicone parts like the atomizer sleeve, and finally, the CONNECT airpath.

Then, remove the glass top and dump out any leftover liquid and rinse it with warm water. Then, fill it with 70% isopropyl alcohol. Go ahead and cover the openings of the glass top and shake vigorously until all debris is removed. Rinse it again with water and then let it dry. Repeat as many times as necessary. After this, it’s time to clean the Atomizer. 

(Cleaning the Atomizer)
First, remove the CONNECT airpath and start by wiping down the base with a lint-free cloth dampened in 70% isopropyl alcohol—then dry it off right away to avoid any lingering moisture.

Remove the atomizer and drop it into a small bowl or cup filled with 70% iso and let it soak for at least 10 minutes—or longer if needed. Once it’s done soaking, use a cotton swab with alcohol to clean the inside of the bowl and the connecting pin contacts. Then let the atomizer air dry completely. This usually takes about one to two hours. 

Now, it’s time to move on to the CONNECT airpath. 

(Cleaning the CONNECT)
Remove the CONNECT airpath andGive it a gentle wipe-down with a cloth dampened in 70% iso, then dry it off right away. Use a cotton swab with alcohol to clean the reclaim channels and atomizer contact points inside the CONNECT. Once it's clean, let it air dry completely before reinstalling.

Once everything is completely dry, it’s time to reassemble your CARTA SPORT:
– First, Snap the CONNECT back into place
– Then, Reinstall the atomizer, ensuring a snug fit.
– Finally, place the glass top back on securely

If you’d like, For extra peace of mind, run a short, low-temp session to burn off any leftover residue before you dive back in.

And that’s it—you’re all set and ready for your next session.