Upon receiving your CARTA Classic, fully charge the device using the included USB-C cable and an AC/DC adapter rated for 5v 1-2A. Charging can take up to 2 hours.
How to turn the unit on:
To turn your device on, click the power button 5 times, upon starting up the unit’s LEDs will blink 3 times. The number of LEDS that blink upon start-up indicates the charge level (ie. 3 LEDs = ~75% battery life).
Loading a dab:
When loading material, there are two main methods available: the cold start and the hot start. The cold start method involves loading the product before firing the atomizer, while the hot start method involves loading the product after the atomizer has reached the set heat. For both methods, it's best to use temperatures between 400°F to 500°F for a more flavorful experience and increase until you find your preferred setting.
Before starting a session press once on the power button to set your heat preset. You can cycle through the 4 preset heat settings by pressing again, once on the power button. You will see a solid blue LED(s) appear indicating which preset the unit is set to.
What temps should I use:
To get the best experience and vapor from your device we recommend using temperatures from 400F to 500F, you can access these temperatures by using the Focus V CARTA App. The presets on the CARTA Classic range from 500F-850F:
Preset 1: 500 F
Preset 2: 630 F
Preset 3: 770 F
Preset 4: 850 F
Once you have found your desired preset double-click twice to initiate a session. While heating, the unit will show a blinking blue LED(s) depending on the preset. Once the set temperature is reached, LEDs will turn to a solid green, indicating that it’s ready to go.
From here you are ready to either load your concentrate in or cap the unit depending on your loading method.
How to inhale:
For the best result, take slow, softer hits. The slower the draw the better the vapor will stack. Softer hits will also ensure that your product does not splash and end up in the inner chamber.
How to check battery life:
Your unit has dual 18350 1200 mAh 3.7v batteries, these batteries are intended to be paired and charged together, if you do pick up another set please make sure to not mix up your pairs. To check your battery life you can click 4 times on the power button. The number of LEDs that appear will correlate to the battery life. Typically for the best care we recommend charging the unit once it reaches the 50% level. Doing so will ensure that your batteries last as long as possible.
How to switch your insert:
The CARTA Classic features 2 inserts that can be used with the Everlast Atomizer, Titanium, and Quartz. These 2 materials will have different effects on your vapor production. Titanium will provide you with denser vapor as well as heat up and retain heat better for a more consistent hit. Whereas Quartz will take a bit longer to heat and produce slightly less vapor but massively boost the flavor of your concentrate.
To switch the insert first remove the atomizer from the base. Once removed turn the ceramic lid clockwise until it detaches from thew lower cylinder. Once separated, place your ceramic lid upside down on a flat surface and then place your new insert into the lid. Locating tabs in the lid help keep the insert centered. With the ceramic lid and new insert still upside down on a flat surface, place the atomizer lower cylinder into the lid and screw it in counter-clockwise. Flip over and install it back on your base.
How to switch the LED preset:
Your CARTA Classic comes with 4 LED presets built-in, 3 colorways, and a stealth mode. You can cycle through these presets by clicking 3 times, to continue cycling again click 3 times. The last mode is the stealth mode which will turn off the LEDs.